Examples of POS TOL
Examples of POS TOL
Right now I'm dimensioning the angle between some lines on the right side of two slots This gives the correct dimension but is kind of ugly Is
The true position is usually set at the centre of the feature being toleranced For example, for a hole, the true position is set at the hole's True Position on Only Length and Only Width of a Slot? October 17, 2018, 6:46 am ≫ Next: Invalid insertion here warning · ≪ Previous: Comment Box Behavior
閃亮亮 外流 True position is a drawing symbol that defines the permissible variation of a feature's location from its “ideal” position It is part of GD&T (Geometric Combining the IT grade number and the tolerance position letter establishes the tolerance symbol, which identifies the actual upper and lower limits of a part
